Installation guide

Enterasys G-Series Hardware Installation Guide 2-1
2
Installation
ThischapterprovidestheinstructionstoinstalltheG3G124‐24,G3G124‐24PandG3G170‐24.
Unlessotherwisenoted,theinstructionsapplytoallswitches.
Equipmentneeded:
• Phillipsscrewdriver
•Flatbladescrewdriver
Followtheorderofthesectionsbelowforcorrectinstallation.
Electrical Hazard: Only qualified personnel should install or service this unit.
Riesgo Eléctrico: Nada mas personal capacitado debe de instalar o darle servicio a esta unida.
Elektrischer Gefahrenhinweis: Installationen oder Servicearbeiten sollten nur durch
ausgebildetes und qualifiziertes Personal vorgenommen werden.
For information about... Refer to page...
Unpacking the G-Series Switch 2-2
Order of Installation Steps 2-3
Mounting the Switch 2-3
Power Supply Installation Considerations 2-5
Installing a Power Supply 2-8
Installing and Removing an IOM 2-10
Connecting Power to the Switch 2-13
Connecting to the Console Port 2-14
Connecting to the Network 2-16
Completing the Installation 2-22
Installing an Optional PoE Module in the G3G124-24 Switch 2-23