Specifications

Security Configuration Command Set
Configuring MAC Locking
11-44 SecureStack B2 Configuration Guide
11.3.4.7 set maclock trap
Use this command to enable or disable MAC lock trap messaging. When enabled, this authorizes
the device to send an SNMP trap message if an end station is connected that exceeds the maximum
value configured using the set maclock firstarrival command. Violating MAC addresses are
dropped from the device’s routing table.
set maclock trap port_string {enable | disable}
Syntax Description
Command Defaults
None.
Command Mode
Read-Write.
Example
This example shows how to enable MAC lock trap messaging on fe.2.3:
port_string Specifies the port on which MAC lock trap messaging
will be enabled or disabled. For a detailed description of
possible port_string values, refer to Section 3.1.1.
enable | disable Enables or disables MAC lock trap messaging.
B2(rw)->set maclock trap fe.2.3 enable