Specifications

Security Configuration Command Set
Configuring VLAN Authorization (RFC 3580)
11-30 SecureStack B2 Configuration Guide
11.3.3.1 set vlanauthorization
Enable or disable the use of the radius vlan tunnel attribute to put a port into a particular vlan as the
result of an authentication. If no port string is entered, the action will be a global setting.
set vlanauthorization [enable | disable] [port_string]
Syntax Description
Command Mode
Read-Write.
Command Defaults
• vlan authentication is disabled by default
• If no port string is entered, the command will be a global setting.
Example
This example shows how to enable VLAN authentication for all ports across the entire stack:
This example shows how to disable VLAN authentication for all Gigabit ports on stack unit 3:
enable Enables the use of VLAN tunnel attributes to a port
disable Restores port assigned VLAN attributes
port string (optional) Specifies which ports to enable or disable the
use of VLAN tunnel attributes. If no port string is
entered, the action will be a global setting. For a detailed
description of possible port_string values, refer to
Section 3.1.1.
B2(rw)-> set vlanauthorization enable
B2(rw)-> set vlanauthorization disable ge.3.*