Specifications

Startup and General Configuration Summary
General Configuration Command Set
2-16 SecureStack B2 Configuration Guide
Purpose
To review, individually configure and manage switches in a SecureStack B2 stack.
Commands
The commands used to review, individually configure and manage switches in a SecureStack B2
stack are listed below and described in the associated section as shown.
• show switch (Section 2.1.10.2)
• show switch switchtype (Section 2.1.10.3)
• show switch stack-ports (Section 2.1.10.4)
• set switch (Section 2.1.10.5)
• set switch copy-sw (Section 2.1.10.6)
• set switch description (Section 2.1.10.7)
• set switch movemanagement (Section 2.1.10.8)
• set switch member (Section 2.1.10.9)
• clear switch member (Section 2.1.10.10)
• show snmp persistmode (Section 2.1.10.11)
• set snmp persistmode (Section 2.1.10.12)
• save config (Section 2.1.10.13)
Considerations About Using Clear Config in a Stack
When using the clear config command (as described in Section 2.1.19.2) to clear configuration parameters
in a stack, it is important to remember the following:
• Use clear config to clear config parameters without clearing stack unit IDs. This command WILL NOT
clear stack parameters and avoids the process of re-numbering the stack.
• Use clear config all when it is necessary to clear all config parameters, including stack unit IDs and
switch priority values.
Configuration parameters and stacking information can also be cleared on the master unit only by
selecting option 10 (restore configuration to factory defaults) from the boot menu on device startup. This
selection will leave stacking priorities on all other units.