Specifications

Security Configuration Command Set
Configuring RADIUS
11-10 SecureStack B2 Configuration Guide
11.3.1.5 set radius accounting
Use this command to configure RADIUS accounting.
set radius accounting {[enable] [disable] [retries retries] [timeout timeout]
[server ip_address port [server-secret]
Syntax Description
Command Mode
Read-Write.
Command Defaults
None.
enable | disable Enables or disables the RADIUS accounting client.
retries retries Sets the maximum number of attempts to contact a
specified RADIUS accounting server before timing out.
Valid retry values are 1 - 2147483647.
timeout timeout Sets the maximum amount of time (in seconds) to establish
contact with a specified RADIUS accounting server before
timing out. Valid timeout values are 1 - 2147483647.
server ip_address
port server-secret
Specifies the accounting server’s:
• IP address
• UDP authentication port (0 - 65535)
• server-secret (Read-Write password to access this
accounting server. Device will prompt for this entry
upon creating a server instance, as shown in the example
below.)