Specifications

Security Configuration Command Set
Configuring RADIUS
SecureStack B2 Configuration Guide 11-9
11.3.1.4 show radius accounting
Use this command to display the RADIUS accounting configuration. This transmits accounting
information between a network access server and a shared accounting server.
show radius accounting [server | counter ip-address | retries | timeout]
Syntax Description
Command Mode
Read-Only.
Command Defaults
If no parameters are specified, all RADIUS accounting configuration information
will be displayed.
Example
This example shows how to display RADIUS accounting configuration information. In this case,
RADIUS accounting is not currently enabled and global default settings have not been changed.
One server has been configured. The SecureStack B2 device allows for up to 10 RADIUS
accounting servers to be configured, with up to 2 active at any given time.
For details on enabling and configuring RADIUS accounting, refer to Section 11.3.1.5:
server (Optional) Displays one or all RADIUS accounting server
configurations.
counter ip-address (Optional) Displays counters for a RADIUS accounting
server.
retries (Optional) Displays the maximum number of attempts to
contact the RADIUS accounting server before timing out.
B2(rw)->show radius accounting
RADIUS Accounting status: Disabled
RADIUS Accounting retries: 2
RADIUS Accounting timeout: 5 seconds
RADIUS Acct RADIUS Acct
Server IP Port
------------ -------------