Specifications

Security Configuration Command Set
Configuring RADIUS
11-4 SecureStack B2 Configuration Guide
11.3.1.1 show radius
Use this command to display the current RADIUS client/server configuration.
show radius [status | retries | timeout | server [index | all]]
Syntax Description
Command Mode
Read-Only.
Command Defaults
If no parameters are specified, all RADIUS configuration information will be
displayed.
Example
This example shows how to display RADIUS configuration information:
Table 11-1 provides an explanation of the command output.
status (Optional) Displays the RADIUS server’s enable status.
retries (Optional) Displays the number of retry attempts before the
RADIUS server times out.
server (Optional) Displays RADIUS server configuration
information.
timeout (Optional) Displays the maximum amount of time (in
seconds) to establish contact with the RADIUS server
before retry attempts begin.
index | all (Optional) Displays configuration information for a
specified server or all RADIUS servers.
B2(rw)->show radius
RADIUS status: Enabled
RADIUS retries: 2
RADIUS timeout: 3 seconds
RADIUS Server IP Address Auth-Port
--------- ------------------ -------
1 100.10.0.100 1812