Specifications

Logging And Network Management Command Set
Monitoring Network Events and Status
SecureStack B2 Configuration Guide 10-21
10.2.2.6 disconnect
Use this command to close an active console port or Telnet session from the switch CLI.
disconnect {ip-addr | console}
Syntax Description
Command Defaults
None.
Command Mode
Read-Write.
Examples
This example shows how to close a Telnet session to host 134.141.192.119:
This example shows how to close the current console session:
ip-addr Specifies the IP address of the Telnet session to be
disconnected. This address is displayed in the output
shown in Section 10.2.2.5.
console Closes an active console port.
B2(rw)->disconnect 134.141.192.119
B2(rw)->disconnect console