Specifications

Port Priority and Rate Limiting Configuration Command Set
Configuring Port Traffic Rate Limiting
SecureStack B2 Configuration Guide 8-13
8.3.3.2 set port ratelimit
Use this command to configure the traffic rate limiting status and threshold (in kilobytes per second)
for one or more ports.
s e t po rt ra te lim it { dis a ble | enable} | port-string priority threshold {disable |
enable} [inbound] [index]
Syntax Description
Command Defaults
• Threshold will be applied to inbound traffic on the port/priority.
• If index is not specified, settings will be applied to index 1, and will overwrite
index 1 for any subsequent rate limits configured.
Command Mode
Read-Write.
disable | enable When entered without a port-string, globally disables or
enables the port rate limiting function. When entered
with a port-string, disables or enables rate limiting on
specific port(s) when the global function is enabled.
port-string Specifies a port on which to set the rate limiting
threshold and other parameters. For a detailed
description of possible port-string values, refer to
Section 3.1.1.
priority Specifies the 802.1D (802.1p) port priority level
associated with the port-string. Options are:
• 0 - 7, with 0 specifying the lowest priority, and
• all to set the rate limiting threshold and other
parameters on all port priority levels associated with
the port-string.
threshold Specifies a port rate limiting threshold in kilobytes per
second. Range is 64125 up to up to a maximum of
2147483647 kilobytes per second.
inbound (Optional) Applies this rate policing rule to inbound
traffic.
index (Optional) Assigns a resource index for this port.