Specifications

Startup and General Configuration Summary
Using WebView
2-6 SecureStack B2 Configuration Guide
2.1.4 Using WebView
By default WebView (Enterasys Networks’ embedded web server for device configuration and
management tasks) is enabled on TCP port number 80 of the SecureStack B2 device. You can verify
WebView status, and enable or disable WebView, as described in the following section.
Displaying WebView status:
To display WebView status, enter show webview at the CLI command prompt.
This example shows that WebView is enabled on TCP port 80, the default port number.
Enabling / disabling WebView:
To enable or disable WebView, enter set webview {enable or disable} at the CLI command
prompt.
This example shows how to enable WebView.
2.1.5 Process Overview: CLI Startup and General Configuration
Use the following steps as a guide to the startup and general configuration process:
1. Starting and navigating the Command Line Interface (CLI) (Section 2.1.6)
2. Configuring switch operation in a stack (Section 2.1.10.1)
3. Setting user accounts and passwords (Section 2.1.11)
4. Setting basic device properties (Section 2.1.12)
5. Configuring Power over Ethernet (PoE) (Section 2.1.13)
6. Downloading a new firmware image (Section 2.1.14)
7. Starting and configuring Telnet (Section 2.1.15)
8. Managing image and configuration files (Section 2.1.16)
9. Configuring the CDP discovery protocol (Section 2.1.17)
10.Clearing and closing the CLI (Section 2.1.18)
11.Resetting the device (Section 2.1.19)
B2(rw)->show webview
WebView is Enabled. Configured listen port is 80.
B2(rw)->set webview enable