Specifications

Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Bridge Parameters
5-22 SecureStack B2 Configuration Guide
5.2.1.16 set spantree priority
Use this command to set the device’s Spanning Tree priority. The device with the highest priority
becomes the Spanning Tree root device. If all devices have the same priority, the device with the
lowest MAC address will then become the root device.
set spantree priority priority [sid]
Syntax Description
Command Defaults
If sid is not specified, priority will be set on Spanning Tree 0.
Command Mode
Read-Write.
Example
This example shows how to set the bridge priority to 4096 on SID 1:
priority Specifies the priority of the bridge. Valid values are
from 0 to 61440 (in increments of 4096), with 0
indicating high priority and 61440 low priority.
sid (Optional) Sets the priority on a specific Spanning
Tree. Valid values are 0 - 4094. If not specified, SID
0 is assumed.
B2(rw)->set spantree priority 4096 1