Specifications

Link Aggregation Control Protocol (LACP)
Configuring Link Aggregation
SecureStack B2 Configuration Guide 3-49
aportpri aportpri Sets the port’s actor port priority. Valid values are 0 -
65535, with lower values designating higher priority.
asyspri asyspri Sets the port’s actor system priority. The LACP
implementation on the SecureStack B2 device uses this
value to determine aggregation precedence when there
are two devices competing for the same aggregator. Valid
values are 0 - 65535, with higher precedence given to
lower values.
NOTE: Only one LACP system priority can be
set on a SecureStack B2 device, using either this
command, or the set lacp asyspri command
(Section 3.5.4.3).
enable (Optional) Enables LACPDU processing on this port.
disable (Optional) Disables LACPDU processing on this port.
padminkey
padminkey
Sets a default value to use as the port’s partner admin
key. Only ports with matching admin keys are allowed to
aggregate. Valid values are 1 - 65535.
padminport
padminport
Sets a a default value to use as the port’s partner admin
value. Valid values are 1 - 65535.
padminportpri
padminportpri
Sets a a default value to use as the port’s partner port
priority. Valid values are 0 - 65535, with lower values
given higher priority.
padminstate
lacpactive |
lacptimeout |
lacpagg | lacpsync |
lacpcollect |
lacpdist | lacpdef |
lacpexpire
Sets a port’s partner LACP administrative state. See
aadminstate for valid options.
padminsysid
padminsysid
Sets a default value to use as the port’s partner system ID.
This is a MAC address.
padminsyspri
padminsyspri
Sets a default value to use as the port’s partner priority.
Valid values are 0 - 65535, with lower values given
higher priority.