Specifications

Port Mirroring
Setting Port Mirroring
SecureStack B2 Configuration Guide 3-31
3.4.2.2 set port mirroring
Use this command to create a new mirroring relationship or to enable or disable an existing
mirroring relationship between two ports.
set port mirroring {create | disable | enable source destination
Syntax Description
Command Defaults
None.
Command Mode
Read-Write.
Example
This example shows how to create and enable port mirroring with fe.1.4 as the source port, and
fe.1.11 as the target port:
NOTE: LAG ports and their underlying physical ports, as described in Section 3.5,
cannot be mirrored.
create | disable |
enable
Creates, disables or enables mirroring settings on the
specified ports.
source Specifies the source port designation. This is the port on
which the traffic will be monitored. For a detailed
description of possible port-string values, refer to
Section 3.1.1.
destination Specifies the target port designation. This is the port that
will duplicate or “mirror” all the traffic on the monitored
port. For a detailed description of possible port-string
values, refer to Section 3.1.1.
B2(su)->set port mirroring create fe.1.4 fe.1.11
B2(su)->set port mirroring enable fe.1.4 fe.1.11