Specifications

Port Configuration Command Set
Setting Auto-Negotiation
SecureStack B2 Configuration Guide 3-23
3.3.4.3 clear port jumbo
Use this command to reset jumbo frame support status to enabled on one or more ports.
clear port jumbo [port-string]
Syntax Description
Command Defaults
If port-string is not specified, jumbo frame support status will be reset on all ports.
Command Mode
Read-Write.
Example
This example shows how to reset jumbo frame support status for 1-Gigabit Ethernet port 14 in unit
3:
3.3.5 Setting Auto-Negotiation
Purpose
To review, disable or enable auto-negotiation.
During auto-negotiation, the port “tells” the device at the other end of the segment what its
capabilities and mode of operation are. If auto-negotiation is disabled, the port reverts to the values
specified by default speed, default duplex, and the port flow control commands.
Commands
The commands used to review and configure auto-negotiation are listed below and described in the
associated section as shown.
• show port negotiation (Section 3.3.5.1)
• set port negotiation (Section 3.3.5.2)
port-string (Optional) Specifies the port(s) on which to reset jumbo
frame support status to enabled. For a detailed
description of possible port-string values, refer to
Section 3.1.1.
B2(rw)->clear port jumbo ge.3.14