Specifications

Process Overview: Port Configuration
Port String Syntax Used in the CLI
SecureStack B2 Configuration Guide 3-3
This example shows the port-string syntax for specifying the 1-Gigabit Ethernet port 14 in unit 3
in the stack.
This example shows the port-string syntax for specifying all 1-Gigabit Ethernet ports in unit 3 in
the stack.
This example shows the port-string syntax for specifying all ports (of any interface type) in all
units in the stack.
3.2 PROCESS OVERVIEW: PORT CONFIGURATION
Use the following steps as a guide to configuring switch ports on the device:
1. Reviewing switch port status (Section 3.3.1)
2. Disabling / enabling switch ports (Section 3.3.2)
3. Setting switch port speed and duplex mode (Section 3.3.3)
4. Enabling / disabling jumbo frame support (Section 3.3.4)
5. Setting auto negotiation (Section 3.3.5)
6. Setting flow control (Section 3.3.6)
7. Setting port mirroring (Section 3.4.2)
8. Configuring link aggregation (Section 3.5.4)
9. Configuring broadcast suppression (Section 3.5.5)
ge.3.14
ge.3.*
*.*.*