Specifications

Startup and General Configuration Summary
Resetting the Device
SecureStack B2 Configuration Guide 2-99
2.1.18.2 exit
Use either of these commands to leave a CLI session.
exit
Syntax Description
None.
Command Defaults
None.
Command Mode
Read-Only.
Example
This example shows how to exit a CLI session:
2.1.19 Resetting the Device
Purpose
To reset one or more device units, and to clear the user-defined configuration parameters.
Commands
The commands used to reset the device and clear the configuration are listed below and described
in the associated sections as shown.
• reset (Section 2.1.19.1)
• clear config (Section 2.1.19.2)
NOTE: By default, device timeout occurs after 15 minutes of user inactivity, automatically
closing your CLI session. Use the set logout command as described in Section 2.1.12.21 to
change this default.
B2(rw)->exit