Specifications

Startup and General Configuration Summary
Configuring CDP
2-90 SecureStack B2 Configuration Guide
2.1.17.1 show cdp
Use this command to display the status of the CDP discovery protocol and message interval on one
or more ports.
show cdp [port-string]
Syntax Description
Command Defaults
If port-string is not specified, CDP information for all ports will be displayed.
Command Mode
Read-Only.
Example
This example shows how to display CDP information for ports fe.1.1 through fe.1.9:
Table 2-7 provides an explanation of the command output.
port-string (Optional) Displays CDP status for a specific port. For a
detailed description of possible port-string values, refer to
Section 3.1.1.
B2(rw)->show cdp fe.1.1-9
Port Status
-----------------
fe.1.1 auto-enable
fe.1.2 auto-enable
fe.1.3 auto-enable
fe.1.4 auto-enable
fe.1.5 auto-enable
fe.1.6 auto-enable
fe.1.7 auto-enable
fe.1.8 auto-enable
fe.1.9 auto-enable