Specifications

set policy maptable response
19-46 Authentication and Authorization Configuration
multiauthportcommand(page19‐37)tosetthenumberofRFC3580users(numusers)allowed
perGigabitport.UptothreeuserscanbeconfiguredperGigabitport.
Syntax
show policy maptable response
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaythecurrentpolicymaptableresponsesetting:
B2(rw)->show policy maptable response
policy
set policy maptable response
SetsthemaptableresponsefromthedefaultofpolicytotunneltoallowuptothreeVLAN
authorizeduserstobeconfiguredperGigabitport.
Syntax
set policy maptable response {policy | tunnel}
Parameters
Defaults
Settopolicy.
Mode
Switchcommand,read‐write.
Usage
Thiscommandputstheswitchineither“policymode”(thedefault)or“tunnelmode,”whichis
RFC3580VLANmapping.
policy Setsthemaptableresponsetopolicy.Thisisthedefaultsetting,which
allowsauthenticationofuptothreemultiauthusersperport.
tunnel Setsthemaptableresponsetotunnel,whichallowsauthentication
ofup
tothreemultiauthusersperport.Thissettingisrequiredtoconfigure
VLANauthorizationformultipleusersperGigabitport.