Specifications

set switch member
SecureStack B2 Configuration Guide 2-11
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtomovemanagementfunctionalityfromswitch1toswitch2:
B2(su)->set switch movemenagement 1 2
Moving stack management will unconfigure entire stack including all interfaces.
Are you sure you want to move stack management? (y/n) y
set switch member
Usethiscommandtoaddavirtualmembertoastack.Thisallowsyoutopreconfigureaswitch
beforethephysicaldeviceisactuallyaddedtothestack.
Syntax
set switch member unit switch-id
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Referto“CreatingaVirtualSwitchConfiguration”onpage2‐3formoreinformationabouthowto
addavirtualswitchtoastack.
Example
Thisexampleshowshowtospecifyaswitchasunit1withaswitchIDof1:
B2(su)->set switch member 1 1
clear switch member
Usethiscommandtoremoveamemberentryfromthestack.
Syntax
clear switch member unit
Parameters
unit Specifiesaunitnumberfortheswitch.
switch‐id SpecifiesaswitchID(SID)fortheswitch.SIDscanbedisplayedwiththe
showswitchswitchtypecommand.
unit Specifiestheunitnumberoftheswitch.