Specifications

set switch
SecureStack B2 Configuration Guide 2-9
set switch
UsethiscommandtoassignaswitchID,tosetaswitch’spriorityforbecomingthemanagement
switchifthepreviousmanagementswitchfails,ortochangetheswitchunitIDforaswitchinthe
stack.
Syntax
set switch {unit [priority value | renumber newunit]}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Examples
Thisexampleshowshowtoassignpriority3toswitch5:
B2(su)->set switch 5 priority 3
Thisexampleshowshowtorenumberswitch5toswitch7:
B2(su)->set switch 5 renumber 7
set switch copy-fw
Usethiscommandtoreplicatethecodeimagefilefromthemanagementswitchtoother
switch(es)inthestack.
Syntax
set switch copy-fw [destination-system unit]
Parameters
Defaults
Ifdestination‐systemisnotspecified,themanagementimagefilewillbereplicatedtoallswitches
inthestack.
unit Specifiesaunitnumberfortheswitch.Valuecanrangefrom1to8.
priorityvalue Specifiesapriorityvaluefortheunit.Validvaluesare1to15withhigher
valuesassigning
higherpriority.
renumbernewunit Specifiesanewnumberfortheunit.
Note: This number must be a previously unassigned unit ID number.
destination‐system
unit
(Optional)Specifiestheunitnumberofunitonwhichtocopythe
managementimagefile.