Specifications

Configuring Port Traffic Rate Limiting
13-10 Port Priority and Rate Limiting Configuration
Configuring Port Traffic Rate Limiting
Purpose
TolimittherateofinboundtrafficontheSecureStackB2deviceonaperport/prioritybasis.The
allowablerangefortheratelimitingis64kilobytespersecondminimumuptothemaximum
transmissionrateallowableontheinterfacetype.
Ratelimitisconfiguredforagivenportandlist
ofpriorities.Thelistofprioritiescanincludeone,
some,oralloftheeight802.1pprioritylevels.Onceconfigured,therateofalltrafficenteringthe
portwiththeprioritiesconfiguredtothatportisnotallowedtoexceedtheprogrammedlimit.If
therateexceedstheprogrammedlimit,frames
aredroppeduntiltheratefallsbelowthelimit.
Commands
Thecommandstoconfiguretrafficratelimitingarelistedbelow.
show port ratelimit
Usethiscommandtoshowthetrafficratelimitingconfigurationononeormoreports.
Syntax
show port ratelimit [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,ratelimitinginformationwillbedisplayedforallports.
Mode
Switchcommand,read‐only.
For information about... Refer to page...
show port ratelimit 13-10
set port ratelimit 13-12
clear port ratelimit 13-13
port‐string (Optional)Displaysrate limitinginformationforspecificport(s).Fora
detaileddescriptionofpossibleport‐stringvalues,referto“ PortString
SyntaxUsedintheCLI”onpage 7‐2.