Specifications

Using the Command Line Interface
SecureStack B2 Configuration Guide 1-5
Using the Command Line Interface
Starting a CLI Session
Connecting Using the Console Port
ConnectaterminaltothelocalconsoleportasdescribedinyourSecureStackB2InstallationGuide.
Thestartupscreen,Figure 1‐1,willdisplayontheterminal.YoucannowstarttheCommandLine
Interface(CLI)by
•usingadefaultuseraccount,asdescribedin“UsingaDefaultUserAccount”
onpage 1‐6,or
•usinganadministratively‐assigneduseraccountasdescribedin“UsinganAdministratively
ConfiguredUserAccount”onpage 1‐6.
Figure 1-1 SecureStack B2 Startup Screen
Connecting Using Telnet
OncetheSecureStackB2devicehasavalidIPaddress,youcanestablishaTelnetsessionfromany
TCP/IPbasednodeonthenetwork.Forinformationaboutsettingtheswitch’sIPaddress,referto
“setipaddress”onpage 3‐11.
ToestablishaTelnetsession:
1. Telnettotheswitch’sIPaddress.

2. Enterlogin(username)andpasswordinformationinoneofthefollowing ways:
–Iftheswitch’sdefaultloginandpasswordsettingshavenotbeenchanged,followthe
stepslistedin“UsingaDefaultUserAccount”onpage 1‐6, or
–Enteranadministratively‐configuredusernameand password.
Thenoticeofauthorization
andthepromptdisplaysasshowninFigure 1‐1.
ForinformationaboutconfiguringTelnetsettings,referto“StartingandConfiguringTelnet”on
page 3 ‐35.
Username:admin
Password:
Enterasys SecureStack B2
Command Line Interface
Enterasys Networks, Inc.
50 Minuteman Rd.
Andover, MA 01810-1008 U.S.A.
Phone: [phone]
E-mail: [e-mail]
WWW: http://www.enterasys.com
(c) Copyright Enterasys Networks, Inc. 2008
Chassis Serial Number: 041800249041
Chassis Firmware Revision: 4.02.xx
B2(su)->