Specifications

Creating and Naming Static VLANs
SecureStack B2 Configuration Guide 10-5
Creating and Naming Static VLANs
Purpose
TocreateanewstaticVLAN,ortoenableordisableexistingVLAN(s).
Commands
set vlan
UsethiscommandtocreateanewstaticIEEE802.1QVLAN,ortoenableordisableanexisting
VLAN.
Syntax
set vlan {create | enable | disable} vlan-list
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
OnceaVLANiscreated,youcanassignitanameusingthesetvlannamecommanddescribedin
“setvlanname”onpage 10‐6.
EachVLANIDmustbeunique.IfaduplicateVLANIDisentered,thedeviceassumesthatthe
AdministratorintendstomodifytheexistingVLAN.
Enter
theVLANIDusingauniquenumberbetween1 and4093.TheVLANIDsof0and4094and
highermaynotbeusedforuser‐definedVLANs.
Examples
ThisexampleshowshowtocreateVLAN3:
B2(su)->set vlan create 3
For information about... Refer to page...
set vlan 10-5
set vlan name 10-6
clear vlan 10-6
clear vlan name 10-7
create|enable|
disable
Creates,enablesordisablesVLAN(s).
vlan‐list SpecifiesoneormoreVLANIDstobecreated,enabledordisabled.