Specifications

show lacp
SecureStack B2 Configuration Guide 7-41
show lacp
Usethiscommandtodisplayinformationaboutoneormoreaggregatorports.
Syntax
show lacp [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,linkaggregationinformationforallLAGswillbedisplayed.
Mode
Switchcommand,read‐only.
Usage
EachSecureStackB2moduleprovides6virtuallinkaggregatorports,whicharedesignatedinthe
CLIaslag.0.1throughlag.0.6.Onceunderlyingphysicalports(thatis,fe.x.x)areassociatedwith
anaggregatorport,theresultingaggregationwillberepresentedasoneLinkAggregationGroup
(LAG)withalag.x.xportdesignation.
Example
Thisexampleshowshowtodisplaylacpinformationforlag.0.1.Thefollowingtabledescribesthe
outputfields.
B2(su)->show lacp lag.0.1
Global Link Aggregation state: enabled
Single Port LAGs: disabled
Aggregator: lag.0.1
Actor Partner
System Identifier: 00:01:F4:5F:1E:20 00:11:88:11:74:F9
System Priority: 32768 32768
Admin Key: 32768
Oper Key: 32768 0
Attached Ports: fe.1.1
fe.1.3
Table 7‐12providesanexplanationofthecommandoutput.
set lacp singleportlag 7-46
clear lacp singleportlag 7-45
show port lacp 7-47
set port lacp 7-48
clear port lacp 7-50
For information about... Refer to page...
port‐string (Optional)DisplaysLACPinformation forspecificLAGport(s).Valid
portdesignationsarelag.0.1‐6.