Installation guide

CUSTOMER RELEASE NOTES
10/17/07 P/N: 9038177-17 Subject to Change Without Notice Page: 11 of 21
F0615-O
Firmware Release 5.0.9.2:
Resolved an issue where the RBT switch would core dump after querying the rbtwsSysDataObjects MIB branch.
Resolved an issue where the RBT-4102-EU and the RBT-1002-EU were not supported in the country code
Hong Kong.
Resolved an issue when the RBT switch would report an SSL error or System communication errors after
generating a certificate signing request via WebView.
Resolved an issue when the current RBT switch configuration was not cleared after using the Quickstart feature
via WebView.
Resolved an issue where clients using a Macbook Pro could not connect to the RBT switches.
Resolved an issue where the Web portal login screen would not propagate to the client after a successful
authentication
Resolved an issue where one RBT switch configured for DAP load balancing and redundancy with a second
RBT switch continually reset after losing contact with configured DAPs.
Resolved an issue where the sixth (or more) DAP would crash using the Quickstart feature.
Resolved an issue when the switch received an ARP packet with a source address of all zero‘s, it would cause a
tunnel crash.
Firmware Release 5.0.6.1:
Added support for the TRPZ-MXR-2 switch.
Resolved an issue where the DAP Operational Power was showing a N/A value for the country code Argentina.
Resolved an issue where an error message reading ―EAP_STORE_ERR‖ would appear on the CLI console of
the RBT-8110.
Resolved an issue where extra characters were added to the banner MOTD after a firmware upgrade on the
RBT switch.
Fixed an issue where a possible unicast flood condition could occur with redundant RBT-8400 switches.
Firmware Release 4.2.5.1:
Static IP configuration for DAPs – These settings are only available through the CLI interface on the switch. The
user now can set a static IP address, RBT switch name or RBT switch address, and VLAN on the Access
Points. These settings are persistent on the RBT-1602 and the RBT-1002 Access Points only for the current
4.2.5.1 firmware.
Resolved an issue where the RBT-4102 and the RBT3K-AG would not boot due to an RSA fingerprint match
failure.
Resolved an issue with the WPA sequence number used to help sync up the per-packet keys between the Intel
3945 A/B/G chipsets and any Access Point in the RBT switch system. Clients would authenticate successfully
against the RADIUS server, but not have any connectivity to the network.
Resolved an issue where extra carriage returns in the banner MOTD would cause the RBT switch to fail an
upgrade and constantly reboot.
Resolved an issue where the RBT-8400 would core crash and lose part of the active configuration upon
upgrade.
Resolved an issue where the RBT switch core crashed after cutting and pasting a ―set port group‖ CLI
command.
Resolved an issue where the Quickstart configuration helper was automatically creating an admin password.
Fixed the length of the CLI entry for the mobility domain name from 16 to 32 characters.
Resolved a CLI command issue where the CLI would lock up after rapidly entering a ―show load‖ command (3-5
times within 5-10 seconds).
Resolved an issue where ―set dap‖ commands would not return a ―succeed: changes accepted‖ notification.
Resolved an issue where a switch reset with multiple core files after a system upgrade. Core resets were
attributed to the enabling of rogue detection in the fabric.