Installation guide

Using the CLI
3-4 Initial Configuration
6. Changethedefaultusernameandpassword:typeusernameandspecifyauniqueusername;
typepasswordandspecifyauniquepassword.
7. EnableManagementVLAN.
a. Typemanagement‐vlanidandspecifyamanagementvlanid.
b. Typemanagement‐vlanenable,andresettheaccesspoint.
8. RefertotheRoamAboutAccessPoint3000ConfigurationGuideforadvanced
configuration
information.
RoamAbout 3000(config)#username JadaPerl
RoamAbout 3000(config)#password G7nq1Z
Confirm new password: G7nq1Z
RoamAbout 3000(config)#
Note: Before enabling the VLAN feature on the access point, you must set up the network switch
port to support tagged VLAN packets from the access point. The switch port must also be
configured to accept the access point’s management VLAN ID and native VLAN IDs. Otherwise,
connectivity to the access point will be lost when you enable the VLAN feature.
RoamAbout 3000(config)#management-vlanid 10
RoamAbout 3000(config)#management-vlan enable
Reboot system now? <y/n>:y
Username: admin
Password:********