Installation guide

ManualsBrandsEnterasys ManualsComputer equipmentEnterasys RoamAbout RBT3K-AG

Using the CLI

RoamAbout Access Point 3000 Hardware Installation Guide 3-3

b. Determinethecodeforyourcountry,andthentypecountryfollowedbyyourcountry

code(forexample,countryUSforUnitedStates).

c. ReboottheRoamAboutAccessPoint3000.

5. IfyouraccesspointusesaDHCPassignedIPaddressgoontochangethedefaultusername

andpassword.

Otherwise,disableDHCPforthis

accesspointasfollows:

a. Typeconfiguretoenterconfigurationmode.

b. TypeinterfaceethernettoaccesstheEthernet interfaceconfigurationmode.

c. DisableDHCP.Typenoipdhcp.

d. SettheIPAddress.Typeipaddressip‐addressnetmaskgateway,whereip‐addressisthe

accesspoint’sIPaddress,netmaskisthenetworkmask

forthenetwork,andgatewayis

thedefaultgatewayrouter.CheckwithyoursystemadministratortoobtainanIPaddress

thatiscompatiblewithyournetwork.

Afterconfiguringtheaccesspoint’sIPparameters,youcanaccessthemanagement

interfacefromanywherewithintheattachednetwork.Thecommandlineinterfacecan

also

beaccessedusingTelnetfromanycomputerattachedtothenetwork.

RoamAbout 3000#country US

Please reset the AP to make the country code change effective

RoamAbout 3000#reset board

Reboot system now? <y/n>: y

Username: admin

Password:********

RoamAbout 3000#

RoamAbout 3000#configure

Enter configuration commands, one per line. End with CTRL/Z

RoamAbout 3000(config)#interface ethernet

Enter Ethernet configuration commands, one per line.

RoamAbout 3000(if-ethernet)#

RoamAbout 3000(if-ethernet)#no ip dhcp

DHCP client state has changed. Please reset AP for change to take effect.

RoamAbout 3000(if-ethernet)#exit