Installation guide

RoamAbout Access Point 3000 Hardware Installation Guide 3-1
3
Initial Configuration
Overview
TheEnterasysNetworksRoamAboutAccessPoint3000includesaWeb‐basedinterface,anda
directconnectiontotheconsoleportforCLImanagement.YoucanalsomanagetheAccessPoint
3000usinganSNMPmanager,suchasEnterasysNetworksNetSightAtlas.
YoucanperformtheinitialconfigurationstepsthroughtheCLI
ortheWebinterface.
TheaccesspointrequestsanIPaddressfromaDynamicHostConfigurationProtocol(DHCP)
serverbydefault.IfaDHCPserverdoesnotrespond,thentheaccesspointusesthedefault
address,192.168.1.1.
IfyouutilizeaDHCPservertoprovisionnewelementsinyourIPnetwork,
useyourDHCPserver
orotherutilitiestodeterminetheIPaddressassignedtothisaccesspoint.Then,usetheDHCP
assignedIPaddresstoconnecttotheaccesspoint.
Using the CLI
TheAccessPoint3000includesanRS‐232serialportthatenablesaconnectiontoaPCorterminal
formonitoringandconfiguration.AttachaVT100‐compatib leterminal,oraPCrunninga
terminalemulationprogramtotheaccesspoint.Youcanusetheconsolecableprovidedwiththis
package,or
useanull‐modemcablethatcomplieswiththewiringassignmentsshownin
Appendix C.
Required Connections
Toconnecttotheconsoleport,completethefollowingsteps:
1. Connecttheconsolecabletotheserialportonaterminal,oraPCrunningterminalemulation
software,andtightenthecaptiveretainingscrewsontheDB‐9connector.
2. ConnecttheotherendofthecabletotheRS‐232serialport
ontheaccesspoint.
3. Makesuretheterminalemulationsoftwareissetasfollows:
•Selecttheappropriateserialport(COMport1or2).
•Setthedatarateto9600baud.
•Setthedataformatto8databits,1stopbit,andnoparity.
•Setflowcontrolto
none.
•SettheemulationmodetoVT100.
•WhenusingHyperTerminal,selectTerminalkeys,notWindowskeys.