Installation guide

Mounting the Access Point
2-2 Hardware Installation
Mounting on a Wall
TomounttheAccessPoint3000onawall,performthe followingsteps:
1. Locateatleasttwomountingholes/slotsonthemountingbracketthatlineupwithawallstud.
2. Usetwoscrewstosecuretheflatsideofthemountingbrackettothewallstud.Useplastic
anchors,orself‐anchoring
screws(notincluded)tosecurethemountingbrackettothe
wallboard,asshownbelow.
3. Slidetheaccesspointoverthemountingbrackettolocatethethreeraisedtabs,asshownin
thefollowingfigure.