User`s guide

Managing Router Configuration Files
7-10 Configuring IP
Managing Router Configuration Files
EachMatrixDFESeriesorN‐SAdeviceprovidesasingleconfigurationinterfacewhichallows
youtoperformbothswitchandrouterconfigurationwiththesamecommandset.Thissection
demonstratesmanagingconfigurationfileswhileoperatinginroutermodeonly.Forasampleof
howtousethesecommandsinterchangeablywith
theMatrixDFESeries/N‐SAsingle
configurationinterfacecommands,referto“ManagingConfigurationandImageFiles”(page 2‐7).
UsetheproceduresinthissectiontoperformthefollowingIPconfigurationfilemanagement
tasks:
• Displayingthe RunningConfiguration
• SavingorErasingtheRunningConfiguration
• RemovingtheRoutingConfigurationfrom
theDevice
• PerformingaBasicRouterConfiguration
Displaying the Running Configuration
Fromanyroutermode,usethiscommandtodisplaythenon‐default,user‐suppliedcommands
enteredwhileconfiguringthedevice:
show running-config
Example
Thisexampleshowshowtodisplaythecurrentrouteroperatingconfigurativen:
Matrix>Router1#show running-config
!
license advanced abcdefg123456789
!
Router id 182.127.62.1
!
route-map 102 permit 1
match ip address 2 4 6 8 110
set next-hop 10.2.1.1 10.2.2.1 10.2.3.1
!
interface vlan 2
ip address 2.1.1.1 255.255.255.0
ip policy route-map 102
ip policy priority only
ip policy loadpolicy round-robin
ip policy pinger on
ip policy pinger interval 10
ip policy pinger retries 4
no shutdown
!
router rip
network 182.127.0.0