User`s guide
Activating Licensed Features
Matrix DFE Series and N-SA User’s Guide 2-13
Clearing User-Defined Configuration Parameters
Usethefollowingcommandtocleartheuser‐definedsystemconfigurationparametersforoneor
moremodulesandresetthosemodulesbacktofactorydefaults:
clear config mod-num | all
Activating Licensed Features
Inordertoenableadvancedfeatures,suchasincreaseduserandportcapacity,redundant
management,advancedroutingprotocols,andextendedACLs,youmustpurchaseandact ivate
thelicensekey(s)applicabletoyourrequirementsandproductasshowninTable 2‐2.Ifyouhave
purchasedoneormorelicenses,youcan
proceedtoactivatethemasdescribedinthissection.If
youwishtopurchasealicense,contactEnterasysNetworksSales.
Enabling Advanced Capacities on Matrix DFE Series or N-SA Devices
UsethefollowingproceduretoactivateadvancedlicensecapabilitiesonMatrixDFESeriesor
N‐SAdevices:
1. Determineyourappropriatelicense‐keyfromtheactivationkeydocumentshippedwithyour
product,orbyviewingthetopoftherunning‐configoutput:
show running-config
2. Entertheapplicablelicensekeyforthecapabilityyouwanttoactivate:
set license {advanced | redundancy | user-capacity | port-capacity} license-
key [slot slot]
3. Activatethelicensebyresettingthedevice:
reset [mod-num | system ]
Note: This command does not affect the switch IP address.
If the module being reset is in a chassis with other active modules, it will inherit system settings from
the system. For a list of factory device default settings, refer to Tab le 1 -1 and Tab l e 1- 2 on
page 1-4.
Table 2-2 Advanced License Capacities per Product
License Advanced Features
DFE-
Platinum
DFE-Gold N-SA
N-EOS-L3 Advanced routing functions, including OSPF,
DVMRP, PIM, LSNAT, and extended ACLs
•••
N-EOS-PPC Increased per-port user capacity to 256, up to a
maximum of 1024 users per module
••
N-EOS-PUC Increased user capacity to 2048 users per chassis
•
N-EOS-RED Management module redundancy
•
Note: Increased per-port user capacity licenses (N-EOS-PPC) must be purchased per slot/module.