User`s guide

Downloading a New Firmware Image
2-10 Getting Started
4. Youcannowsetthedevicetoloadthenewimagefileatstartupusingthesetbootsystem
commandasdescribedin“ReviewingandSelectingaBootFirmwareImage”(page 2‐11).
Downloading Using the Serial Port
Todownloaddevicefirmwareusingtheserial(console)port:
1. WiththeconsoleportconnectedasdescribedintheMatrixDFESeriesorN‐SAInstallation
Guideforyourproduct,powerupthedevi ce.Thefollowingmessagedisplays:
2. Beforethebootupcompletes,pressanykey.TheSystemImageLoaderpromptdisplays.
3. (Optional)
Type?andpressENTER.Thefollowing SystemImageLoadermenudisplays:
4. Typesetbaud115200tosetthedevicebaudrateto115200andpressENTER.
5. Openyourterminalapplicationand,fromthatapplication,settheterminalbaudrateto
115200.
6. FromtheSystemImageLoaderprompt,typedownloadtostart
theZMODEMreceive
process.
7. SendtheimagefileusingtheZMODEMprotocolfromyourterminalapplication.(This
procedurewillvarydependingonyourapplication.)WhentheZMODEMdownloadis
finished,thefollowingmessagedisplays:
Boot ROM Initialization, Version 01.00.01
Copyright (c) 2005 Enterasys Networks, Inc.
SDRAM size: 128 MB
Testing SDRAM.... PASSED.
Loading Boot Image: 01.00.02... DONE.
Uncompressing Boot Image... DONE.
Press any key to enter System Image Loader menu
[System Image Loader
]: ?
?, help - print this list
boot - boot (load and go)
download - start ZMODEM download
list - display available images
log - message log
setbaud <rate> - set baud rate, (9600,38400,57600,115200)
setboot <filename> - change boot image file
showboot - display boot image file
[System Image Loader
]: download
Preparing to receive file...
Writing file...
Download successful.
[System Image Loader
]: