User`s guide

Factory Default Settings
1-4 Features Overview
Spanning Tree version Set to mstp (Multiple Spanning Tree Protocol).
SSH Disabled.
System baud rate Set to 9600 baud.
System contact Set to empty string.
System location Set to empty string.
System name Set to empty string.
Terminal CLI display set to 80 columns and 24 rows.
Timeout Set to 15 minutes.
User names Login accounts set to ro for Read-Only access; rw for Read-Write access;
and admin for Super User access.
VLAN dynamic egress Disabled on all VLANs.
VLAN ID All ports use a VLAN identifier of 1.
Table 1-2 Default Device Settings for Router Mode Operation
Device Feature Default Setting
Access groups (IP security) None configured.
Access lists (IP security) None configured.
Area authentication
(OSPF)
Disabled.
Area default cost (OSPF) Set to 1.
Area NSSA (OSPF) None configured.
Area range (OSPF) None configured.
ARP table No permanent entries configured.
ARP timeout Set to 14,400 seconds.
Authentication key (RIP
and OSPF)
None configured.
Authentication mode (RIP
and OSPF)
None configured.
Dead interval (OSPF) Set to 40 seconds.
Disable triggered updates
(RIP)
Triggered updates allowed.
Distribute list (RIP) No filters applied.
DoS prevention Disabled.
DVMRP Disabled. Metric set to 1.
Hello interval (OSPF) Set to 10 seconds for broadcast and point-to-point networks. Set to 30
seconds for non-broadcast and point-to-multipoint networks.
Table 1-1 Default Device Settings for Basic Switch Operation (continued)
Device Feature Default Setting