User`s guide

Factory Default Settings
Matrix DFE Series and N-SA User’s Guide 1-3
Port duplex mode Set to half duplex, except for 100BASE-FX and 1000BASE-X, which is set to
full duplex.
Port enable/disable Enabled.
Port priority Set to 1.
Port speed Set to 10 Mbps, except for 1000BASE-X, which is set to 1000 Mbps, and
100BASE-FX, which is set to 100 Mbps.
Port trap All ports are enabled to send link traps.
Priority classification Classification rules are automatically enabled when created.
RADIUS client Disabled.
RADIUS last resort action When the client is enabled, set to Challenge.
RADIUS retries When the client is enabled, set to 3.
RADIUS timeout When the client is enabled, set to 20 seconds.
Rate limiting Disabled (globally and on all ports).
SNMP Enabled.
SNTP Disabled.
Spanning Tree Enabled (globally and on all ports).
Spanning Tree edge port
administrative status
Enabled.
Spanning Tree edge port
delay
Enabled.
Spanning Tree forward
delay
Set to 15 seconds.
Spanning Tree hello
interval
Set to 2 seconds.
Spanning Tree ID (SID) Set to 0.
Spanning Tree legacy path
cost
Disabled.
Spanning Tree maximum
aging time
Set to 20 seconds.
Spanning Tree point-to-
point
Set to auto for all Spanning Tree ports.
Spanning Tree port priority All ports with bridge priority are set to 128 (medium priority).
Spanning Tree priority Bridge priority is set to 32768.
Spanning Tree topology
change trap suppression
Enabled.
Spanning Tree transmit
hold count
Set to 3.
Table 1-1 Default Device Settings for Basic Switch Operation (continued)
Device Feature Default Setting