Specifications

IP Configuration Command Set
Configuring PIM
Matrix DFE-Gold Series Configuration Guide 11-47
11.2.7 Configuring PIM
Purpose
To review and configure Protocol Independent Multicast (PIM).
Commands
The commands used to review and configure PIM are listed below and described in the associated
section as shown:
• ip pim sparse mode (Section 11.2.7.1)
• ip pim bsr-candidate (Section 11.2.7.2)
• ip pim dr-priority (Section 11.2.7.3)
• ip pim rp-address (Section 11.2.7.4)
• ip pim rp-candidate (Section 11.2.7.5)
• show ip pim bsr (Section 11.2.7.6)
• show ip pim interface (Section 11.2.7.7)
• show ip pim neighbor (Section 11.2.7.8)
• show ip pim rp (Section 11.2.7.9)
• show ip pim rp-hash (Section 11.2.7.10)
• show ip mroute (Section 11.2.7.11)
• show ip mforward (Section 11.2.7.12)
* Advanced License Required *
PIM is an advanced routing feature that must be enabled with a license key. If you have purchased
an advanced license key, and have enabled routing on the device, you must activate your license
as described back in Section 2.2.4 in order to enable the PIM command set. If you wish to
purchase an advanced routing license, contact Enterasys Networks Sales.