Specifications

IP Configuration Command Set
Reviewing and Configuring the ARP Table
Matrix DFE-Gold Series Configuration Guide 11-19
11.2.3.4 Moving a Config File from Another Routing Module
To copy a router configuration from one module to another, proceed as follows:
1. From the routing module in which you wish to copy a config file, perform a show config on the
file as described in Section 2.2.9.3.
2. Copy the config file to a place where it can be edited with a file editing program.
3. If you only want the router config, delete all the non-routing config elements and save the new
file.
4. Change the routing instance to the module to which the config will be moved as described in
Section 2.3.3.
5. Use the copy command to move the config file to the new module as described in
Section 2.2.9.5.
6. Run the configure command using the new config file as described in Section 2.2.9.4.
11.2.4 Reviewing and Configuring the ARP Table
Purpose
To review and configure the routing ARP table, to enable proxy ARP on an interface, and to set a
MAC address on an interface.
Commands
The commands used to review and configure the ARP table are listed below and described in the
associated section as shown:
• show ip arp (Section 11.2.4.1)
• arp (Section 11.2.4.2)
• ip gratuitous-arp (Section 11.2.4.3)
• ip gratuitous-arp-learning (Section 11.2.4.4)
• ip proxy-arp (Section 11.2.4.5)
• ip mac-address (Section 11.2.4.6)
• arp timeout (Section 11.2.4.7)
• clear arp-cache (Section 11.2.4.8)