Specifications

IP Configuration Command Set
Managing Router Configuration Files
11-12 Matrix DFE-Gold Series Configuration Guide
11.2.2 Managing Router Configuration Files
Each Matrix Series device provides a single configuration interface which allows you to perform
both switch and router configuration with the same command set. When a redundancy license is
available and has been activated, the device also provides redundant, distributed copies of each
router configuration in the event that DFE modules are added or removed from the Matrix chassis.
This section demonstrates managing configuration files while operating in router mode only. For a
sample of how to use these commands interchangeably with the Matrix Series single configuration
interface commands, refer to Section 11.2.3.
Purpose
To review and save the current router configuration, and to disable IP routing.
Commands
The commands used to review and save the router configuration are listed below and described in
the associated section as shown:
• show running-config (Section 11.2.2.1)
• write (Section 11.2.2.2)
• no ip routing (Section 11.2.2.3)