Specifications

Logging And Network Management Command Set
Managing Switch Network Addresses and Routes
10-98 Matrix DFE-Gold Series Configuration Guide
10.2.5 Managing Switch Network Addresses and Routes
Purpose
To display, add or delete switch ARP table entries, to enable or disable RAD (Runtime Address
Discovery) protocol, to display, add or delete IP routing table addresses, and to display MAC
address information.
Commands
Commands to manage switch network addresses and routes are listed below and described in the
associated section as shown.
• show arp (Section 10.2.5.1)
• set arp (Section 10.2.5.2)
• clear arp (Section 10.2.5.3)
• show rad (Section 10.2.5.4)
• set rad (Section 10.2.5.5)
• show ip route (Section 10.2.5.6)
• traceroute (Section 10.2.5.7)
• set ip route (Section 10.2.5.8)
• clear ip route (Section 10.2.5.9)
• show port mac (Section 10.2.5.10)
• show mac(Section 10.2.5.11)
• set mac (Section 10.2.5.12)
• clear mac (Section 10.2.5.13)
• show newaddrtrap (Section 10.2.5.14)
• set newaddrtrap (Section 10.2.5.15)
• show movedaddrtrap (Section 10.2.5.16)
• set movedaddrtrap (Section 10.2.5.17)