Specifications

Overview: Link Aggregation Control Protocol (LACP)
Configuring Link Aggregation
Matrix DFE-Gold Series Configuration Guide 3-97
3.5.4.1 show lacp
Use this command to display the global LACP enable state, or to display information about one or
more aggregator ports. Each Matrix Series module provides 4 virtual link aggregator ports, which
are designated in the CLI as lag.0.1 through lag.0.4. Once underlying physical ports (i.e.; fe.x.x,
ge.x.x) are associated with an aggregator port, the resulting aggregation will be represented as one
Link Aggregation Group (LAG) with a lag.x.x port designation.
show lacp [state | port-string]
Syntax Description
Command Defaults
• If state is not specified, aggregator information will be displayed for specified
ports.
• If port-string is not specified, link aggregation information for all ports will be
displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display information for aggregator port 4
:
Table 3-9 provides an explanation of the command output.
state (Optional) Displays the global LACP enable state.
port-string (Optional) Displays LACP information for specific LAG
port(s). Valid port designations are lag.0.1 - 4.
Matrix(rw)->show lacp lag.0.4
Aggregator: lag.0.4
Actor Partner
System Identifier: 00:e0:63:9d:b5:87 00:00:00:00:00:00
System Priority: 32768 32768
Admin Key: 32768
Oper Key: 32768 32768
Attached Ports: None.