Specifications

Port Configuration Command Set
Configuring Link Traps and Link Flap Detection
Matrix DFE-Gold Series Configuration Guide 3-69
3.3.8.2 set port trap
Use this command to enable or disable ports for sending SNMP trap messages when their link status
changes.
set port trap port-string {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to disable link traps for Fast Ethernet port 3 in module3:
port-string Specifies the port(s) for which to enable or disable link trap
messages. For a detailed description of possible port-string
values, refer to Section 3.1.1.
enable | disable Enables or disables link traps.
Matrix(rw)->set port trap fe.3.3 disable