Specifications

Preparing the Device for Router Mode
Reviewing and Configuring Routing Modules
2-182 Matrix DFE-Gold Series Configuration Guide
Figure 2-8 Enabling the Switch for Routing
2.3.2 Reviewing and Configuring Routing Modules
Purpose
To review and configure routing on one or two modules.
Commands
The commands used to review and configure routing modules are listed below and described in the
associated sections as shown.
• show router (Section 2.3.2.1)
• set router (Section 2.3.2.2)
• clear router (Section 2.3.2.3)
• router (Section 2.3.2.4)
Matrix(rw)->set router 1
Matrix(rw)->router 1
Matrix>Router1>enable
Matrix>Router1#configure terminal
Enter configuration commands:
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip address 182.127.63.1 255.255.255.0
Matrix>Router1(config-if(Vlan 1))#no shutdown