Specifications

General Configuration Command Set
Configuring CDP and Cisco Discovery Protocol
Matrix DFE-Gold Series Configuration Guide 2-151
2.2.10.7 clear cdp
Use this command to reset CDP discovery protocol settings to defaults.
clear cdp {[state] [port-state port-string] [interval] [hold-time] [auth-code]}
Syntax Description
Command Defaults
At least one optional parameter must be entered.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the CDP state to auto-enabled:
state (Optional) Resets the global CDP state to auto-enabled.
port-state
port-string
(Optional) Resets the port state on specific port(s) to
auto-enabled.
interval (Optional) Resets the message frequency interval to 60
seconds.
hold-time (Optional) Resets the hold time value to 180 seconds.
auth-code (Optional) Resets the authentication code to 16 bytes of 00
(00-00-00-00-00-00-00-00).
Matrix(rw)->clear cdp state