Specifications

Security Configuration Command Set
Configuring Multiple Authentication
13-142 Matrix DFE-Gold Series Configuration Guide
13.3.10.16 clear multiauth session-timeout
Use this command to clear multiple authentication session-timeout values, for an active session,
back to the default values. This command can clear the session-timeout values, in seconds, for the
following authentication types: dot1x, pwa, mac, and cep.
clear multiauth session-timeout [cep | dot1x | mac | pwa]
Syntax Description
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
300 seconds for each of the multiple authentication types.
Examples
This example shows how to clear the session-timeout values, for an active session, for cep and mac
authentication types, to the default value of 0 seconds:
This example shows how to clear the session-timeout values, for an active session, for all
authentication types, to the default value of 0 seconds:
cep | dot1x | mac |
pwa
Specifies authentication type:
• cep — Enterasys Convergence End Point Authentication
• dot1x— IEEE 802.1X Port-Based Network Access
Control
• mac — Enterasys Mac Authentication
• pwa — Enterasys Port Web Authentication
Matrix(rw)->clear multiauth idle-timeout cep
Matrix(rw)->clear multiauth idle-timeout mac
Matrix(rw)->set multiauth idle-timeout