Specifications

Security Configuration Command Set
Configuring Multiple Authentication
Matrix DFE-Gold Series Configuration Guide 13-139
13.3.10.13 clear multiauth idle-timeout
Use this command to clear multiple authentication idle-timeout values, for an idle session, back to
the default values. This command can clear the idle-timeout values, in seconds, for the following
authentication types: dot1x, pwa, mac, and cep.
clear multiauth idle-timeout [cep | dot1x | mac | pwa]
Syntax Description
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
300 seconds for each of the multiple authentication types.
Examples
This example shows how to clear the idle-timeout session values for cep and mac authentication
types, back to default value of 300 seconds:
This example shows how to clear the idle-timeout session values for all authentication types, back
to the default value of 300 seconds:
cep | dot1x | mac |
pwa
Specifies the authentication type:
• cep — Enterasys Convergence End Point Authentication
• dot1x— IEEE 802.1X Port-Based Network Access
Control
• mac — Enterasys Mac Authentication
• pwa — Enterasys Port Web Authentication
Matrix(rw)->clear multiauth idle-timeout cep
Matrix(rw)->clear multiauth idle-timeout mac
Matrix(rw)->set multiauth idle-timeout