Specifications

Security Configuration Command Set
Configuring Convergence End Points (CEP) Phone Detection
13-108 Matrix DFE-Gold Series Configuration Guide
13.3.8.14 clear cep
Use this command to clear convergence end points parameters.
clear cep {[all | policy | detection <detection-id> | users <port-string>] [port
port-string {all | cisco | h323 | siemens |sip}]}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to clear all CEP policy
parameters
all Restores factory defaults to all CEP configuration
information.
policy Restore factory defaults to CEP policy configuration.
detection
<detection-id>
Restore factory defaults to CEP detection group
configuration. detection-id is the CEP configuration group
id. Valid values are 1 - 2147483647.
users
<port-string>
Clear discovered Convergence Endpoints on specific
port(s). For a detailed description of possible port-string
values, refer to Section 3.1.1.
port port-string
all | cisco | h323 |
siemens | sip
Resets the CEP default enable state to disabled on specific
port(s) for all detection types or individual detection types
of Cisco, H.323, Siemens, or SIP phone detection. For a
detailed description of possible port-string values, refer to
Section 3.1.1.
Matrix>clear cep policy