Specifications

Security Configuration Command Set
Configuring Convergence End Points (CEP) Phone Detection
Matrix DFE-Gold Series Configuration Guide 13-103
13.3.8.9 set cep detection-id type
Use this command to specify whether a phone detection group will use H.323, Siemens or SIP as
its phone discovery type.
set cep detection-id id type {h323 | siemens | sip}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the phone detection type to H.323 for CEP group 1
:
NOTE: This command applies only to Siemens, H.323, and SIP phone detection. Cisco
detection uses CiscoDP as its discovery method.
NOTE: There are currently 3 manual detection types (Siemens, H323, SIP). Under
manual detection configuration, for each of the types, the “Endpoint Phone Type” will be
listed correctly, however the high and low ports will not reflect default ports for the
“Endpoint Phone Types”. The user will have to configure the port low and high options to
match their needs for the Endpoint Phone Type being configured, as described in
Section 13.3.8.12.
detection-id id Specifies a CEP configuration group ID. This group must
be created and enabled using the set cep detection-id
command as described in Section 13.3.8.8. Valid values are
1 - 2147483647.
h323 | siemens |
sip
Specifies the phone type to detect as H.323,Siemens or SIP.
Matrix>set cep detection-id 1 type h323