Specifications

Routing Protocol Configuration Command Set
Configuring OSPF
12-32 Matrix DFE-Gold Series Configuration Guide
• Set a priority to help determine the
OSPF designated router for the
network.
ip ospf priority (Section 12.2.3.5)
• Adjust timers and message
intervals.
timers spf (Section 12.2.3.6)
ip ospf retransmit-interval (Section 12.2.3.7)
ip ospf transmit-delay (Section 12.2.3.8)
ip ospf hello-interval (Section 12.2.3.9)
ip ospf dead-interval (Section 12.2.3.10)
• Configure OSPF authentication. ip ospf authentication-key (Section 12.2.3.11)
ip ospf message digest key md5 (Section 12.2.3.12)
Configure OSPF Areas.
• Configure an administrative
distance.
distance ospf (Section 12.2.3.13)
• Define the range of addresses to be
used by Area Boundary Routers
(ABRs).
area range (Section 12.2.3.14)
• Enable area authentication. area authentication (Section 12.2.3.15)
• Define an area as a stub area. area stub (Section 12.2.3.16)
• Set the cost value for the default
route that is sent into a stub area.
area default cost (Section 12.2.3.17)
• Define an area as an NSSA. area nssa (Section 12.2.3.18)
Create virtual links. area virtual-link (Section 12.2.3.19)
Enable passive OSPF mode on an
interface.
passive-interface (Section 12.2.3.20)
Enable redistribution from non-OSPF
routes.
redistribute (Section 12.2.3.21)
Table 12-2 OSPF Configuration Task List and Commands (Continued)
To do this... Use these commands...