Installation guide

Preparing to Install the 4H4285-49
3-8 Installation
3. Slidethemoduleintotheslotuntilyoucanengagethetopandbottomlockinglevers
withthechassisasshowninFigure 3‐2.
4. RefertotheCautionnoteabove,thenrotatethetwoleversintothe closedposition.
5. Ifthechassisinwhichthemoduleisinstalledwaspowereddown
fortheinstallation,
turnthepowersupplieson.ChecktoseethatthemoduleCPULEDsettlesatsolid
greenafterafewminutes.IftheLEDdoesnotturnsolidgreen,refertoChapter 4for
troubleshootingdetails.
Caution: In step 4, do not force the locking levers to the point that they touch the face of
the front panel. Forcing the locking levers to this point could damage the module and
chassis.
Precaución: En el paso 4, tenga cuidado de no llevar las palancas de cierre a un punto
en donde estén en contacto con el panel frontal. Si lo hace, podría dañar el módulo o el
chasis.