Installation guide

Installing an Optional Mini-GBIC
3-6 Installation
Installation
ToinstallaMini‐GBICwithanMT‐RJconnection,refertoFigure 3‐3.ForanLC
connection,refertoFigure 3‐4.ForanRJ45connection,refertoFigure 3‐5.Thenproceed
asdescribedbelow.
1. HoldtheMini‐GBICwithitstopsidefacingupandits7‐pinedge
connectorfacingthe
portslot.
2. CarefullyaligntheMini‐GBICwiththeportslot.
3. PushtheMini‐GBICintotheportslotuntiltheMini‐GBIC“clicks”andlocksinto
place.
Figure 3-3 Mini-GBIC with MT-RJ Connector
Note: If the Mini-GBIC is one with an RJ45 connector such as an MGBIC-02 (Figure 3-5),
the installation procedure is the same as described below. However, the Mini-GBIC has a
wire handle to release it.
1 Mini-GBIC (MGBIC-MT01) 4 Port slot
2 Mini-GBIC
, top side 5 Mini-GBIC, protective dust cover
3 7-Pin edge connector (insertion side) 6 Release tab
1
2
3
4
5
6
1
2
3
4
5
6
7G-6MGBIC-A
Ã
Â
Å
À
Á
Ä