Installation guide

Matrix DFE-Gold Series Installation Guide 3-1
3
Installation
Thischapterprovidestheinstructionstoinstallthe4G4202‐72and4G4282‐49DFE‐Gold
modules,andanoptionalnetworkexpansionmodule.
APhillipsscrewdriverisneededtoinstalltheoptionalnetworkexpansionmoduleinto
the4G4282‐49.Followtheorderofthesectionslistedbelowtocorrectlyinstallthe
modules.
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de
instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und
qualifiziertes Personal vorgenommen werden.
Important Notice
Read the Release Notes shipped with the DFE-Gold module to check for any exceptions to the
supported features and operation documented in this guide.
Note: Unless otherwise noted, the installation instructions apply to both DFE-Gold
modules.
For information about... Refer to page...
Unpacking the DFE-Gold Module
3‐2
Installing Optional Network Expansion Modules
3‐2
Installing an Optional Mini-GBIC
3‐5
Module Placement and Rules
3‐9
Installing the DFE Module into a Chassis 3-11
Connecting to the Network 3-15
Connecting to COM Port for Local Management 3-23